Safety Notes; Installation Instructions; Symbol Description - Hansgrohe Quattro 15930180 Instrucciones De Montaje

6

Safety Notes

Gloves should be worn during installation to prevent
6
crushing and cutting injuries.
The hot and cold supplies must be of equal
6
pressures.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The fittings must be mounted in an insulated manner
and with sound insulation. (see page 32)
Installation example (see page 31)
A Quattro 4-Way Diverter Valve
B Shut off valve
C Thermostatic mixer
D Thermostatic mixer with shut off unit
4
English
Assembly (see page 32)
1. Plaster in the installed and checked stop valve, in
2. Apply PCI-Lastogum or similar sealing compound
3. Put gasket over the plastic sleeve of the Quattro

Symbol description

Assembly see page 32
case of pre-wall installation cover it with a panel .
After the plastered wall surface is dry seal the gap
between wall and plastic sleeve of the Quattro four-
way-diverter with silicone (free from acetic acid!).
on the wall in accordance with manufacturers
indications.
four-way-diverter.
Important! The gasket is not suitable for
hot glue.
If the Quattro four-way-diverter should be hot glued,
please take care that it is not damaged.
Do not use silicone containing acetic acid!
Dimensions (see page 33)
Spare parts (see page 34)
Test certificate (see page 33)
Final assembly (see page 35)