Maintenance And Inspection - Metabo HPT DV 20VD Instrucciones De Manejo

English
APPLICATIONS
○ By combined actions of ROTATION and IMPACT:
Boring holes in hard materials (concrete, marble, granite,
tiles, etc.)
○ By ROTATIONAL action:
Boring holes in metal, wood and plastic.
SPECIFICATIONS
Voltage*
Power input
Speed range
No load speed
Steel
Capacity Concrete
Wood
Full-load impact rate
Weight
* Be sure to check the nameplate on product as it is subject
to change by areas.
NOTE
Due to metabo HPT's continuing program of research
and development, the specifi cations herein are subject
to change without prior notice.
MOUNTING AND OPERATION
Action
Insulated gripping surface
Fixing and removing side handle
Using depth stopper
Mounting and dismounting of
the bit
Selecting rotation direction
Selecting the operating mode
Switch operation
Locking-on the switch
Releasing the switch
Change rotation speed
Selecting accessories
Selecting the appropriate drill bit
○ When boring concrete or stone
Use the drill bits specifi ed in the Optional Accessories.
○ When boring metal or plastic
Use an ordinary metalworking drill bit.
○ When boring wood
Use ordinary woodworking drill bit.
However, when drilling 6.5 mm or smaller holes, use a
metalworking drill bit.
(110 V, 120 V, 127 V, 220 V,
230 V, 240 V)
860 W*
1 2
0 – 1100 min 0 – 3000 min
-1
(/min)
13 mm 8 mm
20 mm 13 mm
40 mm 25 mm
8100 min -1 22000 min
(/min) (/min)
3.0 kg
Figure Page
1
2
3
4
5
6
7
8
9
10
―

MAINTENANCE AND INSPECTION

1. Inspecting the drill bits
Since use of an abraded drill bits will cause motor
malfunctioning and degraded effi ciency, replace the drill
bits with a new one or resharpening without delay when
abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power
tool. Exercise due care to ensure the winding does not
become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes
-1
For your continued safety and electrical shock
(/min)
protection, carbon brush inspection and replacement on
this tool should ONLY be performed by a metabo HPT
Authorized Service Center.
5. Replacing supply cord
If the replacement of the supply cord is necessary, it has
-1
to be done by metabo HPT Authorized Service Center to
avoid a safety hazard.
CAUTION
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
NOTE
Due to metabo HPT's continuing program of research
and development, the specifi cations herein are subject to
change without prior notice.
13
13
13
13
14
14
14
14
14
15
16
4