Dyson pure hot+coollink Manual De Instrucciones página 52

Heating and cooling modes
Appliance is in cooling mode
Press the blue cooling mode button to enter cooling mode.
The power button light will change from red to blue to indicate that
you have entered cooling mode. To adjust the airflow speed use the
airflow control button or use auto mode for automatic control.
Appliance is in heating mode
Press the red thermostat control button until the digital display shows the target room temperature. The power button light will change from blue
to red to indicate that you have entered heating mode. The heating symbol will be red while heating and will change to white when the target
room temperature has been reached. Once the target room temperature has been reached, the appliance will stop heating the air. If the room
temperature falls below the target temperature, the appliance will start to heat again. The red circle surrounding the power button remains on
when the product is in heater mode. To adjust the airflow speed use the airflow control button or use auto mode for automatic control.
Room heating to 23°C Room heated to 23°C or above
On first use, the appliance will default to a temperature 3°C higher
than the detected room temperature. Thereafter, the appliance will
remember the last target temperature set.
Each time the heating mode is selected, it conducts a short
calibration cycle. Airflow will be automatically controlled during
this cycle. Once the calibration cycle is complete, it will revert to the
selected airflow speed.
52