Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks Pro 2103902CT Manual Del Operador

EN
7.5

ATTACH THE AUXILIARY HANDLE

1. Remove the screws (1) from the handle with a
Phillips screwdriver (not provided).
2. Attach the auxiliary handle (2) and lower clamp (3)
on the shaft.
1
3. Set the auxiliary handle in the most comfortable in
use position.
4. Tighten the screws.
2
7.6

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
1
7.7

REMOVE THE BATTERY PACK

1. Push and hold the battery release button (1).
3
WARNING
English
2. Remove the battery pack from the machine.
8

OPERATION

Before you operate the machine, read and understand
the safety regulations and the operation instructions.
Be careful when you operate the machine.
8.1

CONTROLS

8.2

START THE MACHINE

1. Pull the lock-out button (2) and pull the trigger (3).
1
2. Push the speed switch (1) to the desired operating
speed. Push the speed switch to position 1 for low
speed or position 2 for high speed.
8.3

STOP THE MACHINE

1. Release the trigger to stop the machine.
8.4 ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets
worn shorter. You can adjust the length of the cutting
line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade
cuts the excess length.
Bump knob
8

IMPORTANT

WARNING
2
3