Attach The Auxiliary Handle; Install The Battery Pack; Remove The Battery Pack; Operation - GreenWorks Pro ST60B02 Manual Del Operador

EN
5. Tighten the screw with the allen key (13).
8.5 ATTACH THE AUXILIARY
HANDLE
1. Remove the screws from the handle with a Phillips
screwdriver (not provided).
2. Attach the auxiliary handle (6) and lower clamp (16) on
the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
6
8.6

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
16
WARNING
English
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.7

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
9

OPERATION

Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1

START THE MACHINE

1. Push the lock-out lever (3) and pull the trigger (4).
2. Push the speed switch (5) to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
9.2

STOP THE MACHINE

1. Release the trigger to stop the machine.
8
1
IMPORTANT
WARNING
3
5
4