Attach The Guard; Assemble The Shaft; Attach The Auxiliary Handle - GreenWorks Pro STC404 Manual Del Operador

WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
8.2

ATTACH THE GUARD

WARNING
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with the
supplied hex wrench.
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw
holes on the trimmer head.
4. Tighten the screws.
English
8.3

ASSEMBLE THE SHAFT

1. Loosen the screw on the coupler (8).
2. Push in the release button on the lower shaft (9).
3. Align the release button with the positioning hole
and slide the two shafts together.
Release button
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw with the hex wrench (13).
9
8.4

ATTACH THE AUXILIARY HANDLE

1. Remove the knob (16) from the handle.
2. Attach the auxiliary handle and lower clamp (15) on
the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Put the bolt (14) through the holes.
5. Tighten the auxiliary handle with the knob.
7
7
8
6
Positioning hole
13
Hex screw
14
15
16
EN