Looking After Your Machine; Additional Information; Dyson Link App Connectivity - Dyson pure cool DP04 Guia Del Usuario

Looking after your machine

To always get the best performance
from your Dyson purifying fan, it is
important to regularly clean it and
check for blockages.
Cleaning
If dust accumulates on the surface
of your machine, wipe dust from
the loop amplifier, filter unit
and other parts with a dry or
damp cloth.
Look for blockages in the air inlet
holes on the filter and the small
aperture inside the loop amplifier.
Use a soft brush to remove dust
and debris.
Don't use detergents or polishes to
clean the machine.
Changing your filters
The Dyson Link app and LCD
screen on your machine will
indicate when to change
your filters.
Don't use your Dyson purifying fan
without the filters in place. Unplug
your machine from the mains
electricity supply before cleaning or
changing filters.
16
Error codes
If your machine shows an error
code, try turning it off and then
on again. If this doesn't clear
the error code contact Dyson
Customer Care.
For further information and
support about the care and
maintenance of your machine and
replacing the filters go to the Dyson
Link app or online:
www.dyson.com/support

Additional information

CONTROL WITHOUT REMOTE
• The machine can be controlled through your Dyson Link app.

DYSON LINK APP CONNECTIVITY

• You must have a live internet connection in order for the Dyson Link app to work.
• The machine can connect to either 2.4GHz or 5GHz networks which includes most
modern routers. Check your router documentation for compatibility.
• The Dyson Link app requires an iOS device with at least iOS version 10* or an Android
device with at least Android version 5.
• Your mobile device must have Bluetooth
®
Low Energy) in order to set up a connection with the machine. Check your device
specification for compatibility.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by Dyson is under license.
– BLE/Wi-Fi 2.4GHz – 2.4835GHz
– Wi-Fi 5.150GHz to 5.850GHz
Supported Wi-Fi protocols:
– IEEE802.11a
– IEEE802.11b (Not recommended)
– IEEE802.11g
– IEEE802.11n
REPLACEABLE PARTS
BATTERY REPLACEMENT
CAUTION
• Unscrew the battery compartment on the remote control. Loosen the base and pull to
remove the battery.
• Do not install backwards or short circuit the batteries.
• Do not attempt to dismantle or charge the batteries. Keep away from fire.
• Follow battery manufacturers' instructions when installing new batteries (battery type
CR 2032).
• Always replace the screw in the remote control and refer to the battery hazard in the
warning section.
wireless technology 4.0 support (Bluetooth