Cleaning - Drive Harmony 14200 Manual De Instrucciones

5. Cleaning

It is important to follow the cleaning procedures before using the system.
Wipe down the Control Unit with a damp cloth pre-soaked with a mild detergent. Avoid
contact with dust and proximity to dusty areas. Make sure that any cleaning agents you
use will not harm or corrode the plastic casing on the Control Unit . If your doctor or
medical facilities have other special cleaning instruction, please follow the professional
instruction.
CAUTION: Do not immerse or soak Control Unit .
WARNING: Do not remove the housing of the Control Unit to avoid electrical
shock. All disassembly or repair should be done by professional technicians
CAUTION: The Control Unit does not need oil lubrication, please do not disas-
semble the system.
Cover Material:
• Silver Ion
+
• Polyfiber/ Polyurethane Stretch
Wipe down the mattress unit with a damp cloth pre-soaked with warm water containing
a mild detergent. Approved intermediate level disinfectants may be used according to
the cover material. Please refer to the chart below for recommended disinfectants.
The mattress top cover can be completely removed for laundry with water temperature
up to 95°C; however, it is recommended that the user still check with local policy to
determine the time/temperature ratio required to achieve thermal disinfec¬tion. After
cleaning, please avoid dust and proximity to dusty areas. All parts should be air dried
thoroughly before use.
Recommended
Acceptable
Not Recommended
CAUTION: After cleaning, dry the mattress without direct exposure of sunlight.
Polyurethane Stretch Top Cover
Quaternary
Chlorine Bleach (1:10)
Phenolics
Vinyl Bottom Cover
Phenolics
Quaternary, Chlorine
Bleach (1:10)
Quat/Isopropyl
13