Important Safety Instructions; Product Warranty - Master PH-1000 Manual De Instrucciones

Important Safety Instructions

Heat guns are a source of extremely high-temperature flameless heat (up to 1050˚F /
566˚C). Extreme caution should be observed when using these products. READ and
FOLLOW these instructions.
Use only on properly-rated electrical
circuits.
Connect to properly grounded outlets
only.
Disconnect from power source during
service and when replacing parts.
115V/15A or 230V/8A
To reduce risk of fire or electric
shock, do not expose heat gun to
rain or moisture.
Store indoors.
Do not use near flammable materials
or where fumes, gases or dust are
present.
Do not use in presence of explosive
atmosphere.
Keep nozzle at least 1"/2.5 cm from
work surface.
Do not apply to the same place for a
long time.
Be aware that heat may be conducted
to combustible materials that are out
of sight.
Use in well-ventilated area.
Use caution in confined areas.
Do not leave heat gun unattended
when it is switched on.
Always hold gun or place on its stand
(see below) when in use.
Place heat gun on its stand (built-in
or external) after use and allow it to
cool down before storage.
4
When using an extension cord,
use only a 3-prong grounded cord
rated equal to or greater than the
appliance.
Connect to properly grounded outlets
115V/15A or 230V/8A
only.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
Keep away from children and persons
with reduced physical, sensory
or mental capabilities or lack of
experience or knowledge.
Do not direct air stream at people
or pets.
Wear safety glasses at all times.
Do not touch nozzle until cool.
Recycle properly.
www.masterappliance.com
Introduction & Product Warranty
Introduction
The Proheat Heat Gun is a compact, lightweight, easy-to-use heat gun. Its compact size and
®
lightweight design make it easy to use in close quarters with minimum operator fatigue. This
multi-purpose tool provides a fast flow of heated air and is well suited for a variety of flameless
heat applications such as activating adhesives, bending and forming plastics, defrosting
frozen coils, drying negatives and parts, heating solids and liquids, loosening nuts and bolts,
removing vinyl, shrinking tubing and packaging, softening materials and stripping paint. It's
your dependable answer, "wherever a fast, portable, heat is the need." NOTE: Users should
independently evaluate the suitability of the product for their application.

Product Warranty

Master Heat Tools are carefully tested and inspected before being shipped from the factory. We warrant
our products to be free from defects in materials and workmanship, under normal use and service, for
one year from date of purchase. In the event of a defect in materials or workmanship we will either repair
or replace, at our option, without charge any part which in our judgement shows evidence of such defect.
Warranty does not apply to wearable items such as attachments or heating elements, which require peri-
odic replacement, nor does it apply if the heat tool has been misused, abused, tampered with or altered.
At the end of the warranty period, Master Appliance shall be under no further obligation, expressed
or implied. Master Appliance assumes no responsibility for, and this warranty shall not cover, any
incidental or consequential damages from any defect in products or their use.
This warranty gives you specific rights. You may also have other rights which may vary from state
to state. Warranty information is included within the Instruction Manual for each product or may be
obtained by contacting Master's Customer Service Department.
Master Appliance Corp.
2420 18th Street
Racine, WI 53403-2381
USA
262-633-7791
800-558-9413 (USA)
sales@masterappliance.com
www.masterappliance.com
www.masterappliance.com 5