Velleman CHLSC2 Manual Del Usuario página 4

covered by y the warranty.
• Only use th he device for its inte
device in a
• Damage ca aused by disregard o
manual is n not covered by the w
not accept
problems
4. Use
Refer to the i
• Connect a
(connecting
matching w wire colours. Do not
• Obtain a su uitable 12VDC/5A po
PS1255) a and connect it to the
other end i
• Aim the rem
controller t to control the outpu
• Switch the
control. To
• Select the
correspond ding colour button o
• To increase e or decrease outpu
button n (8 gradations).
• Press the e effect buttons to gen
Strobe, Fad
5. Batte ery
Refer to illust tration C on page 2
• The remote e control uses 1 bat
battery (inc
• To (re)plac ce the battery, press
cover [C1] ] and pull [C2] to s
• Insert the
battery com mpartment by pushi
the remote e control until it snap
08.12.2010
n unauthorised way
responsibility for an
llustrations on page
LED strip (not includ
g tools not included
into the mains.
mote control [B] to
LED strip on with th
switch it off again,
desired light output
de or Smooth.
cluded).
battery with the righ
CHL LSC2
ended purpose. Usin
y will void the warra
of certain guidelines
warranty and the de
ny ensuing defects o
e 2 of this manual.
ded) to the controlle
). Make sure to con
t short-circuit any w
ower adaptor (not in
e controller [A1]. P
wards the IR LED [A
t of the LED strip.
he ON button on the
press the OFF butto
t colour by pressing
n the remote contro
t brightness, press
nerate different effe
of this manual.
tery type 3V lithium
s on the side of the
lide it open.
ht polarity and close
ing it back into the
ps into place.
4
Rev. 01
ng the
nty.
s in this
ealer will
or
er [A2]
nect
wires.
ncl., e.g.
lug the
A3] of the
e remote
on.
the
ol.
the or
cts: Flash,
m CR2025
battery
e the
housing of
©Velleman nv