Connecting The Monitor Electrically - Dometic M75LX AHD Instrucciones De Montaje

M75LX AHD
• Check beforehand that there is sufficient space on the other side for the drill head to come out
(fig. 2, page 4).
• Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger washers or
plates).
• Make sure you can lay the connection cable to the monitor.
Choosing the installation location (fig. a, page 7)
➤ Place the monitor on the monitor bracket.
➤ Position the monitor and the attached monitor bracket provisionally.
➤ Mark the outlines of the corners of the support base on the dashboard.
➤ Take the monitor off the monitor bracket.
Screwing the monitor bracket onto the dashboard
➤ Hold the support base within the outlines marked beforehand.
➤ Fasten the monitor bracket with the self-tapping screws.
Fastening the monitor
➤ Set the monitor on the monitor bracket and secure it with the knurled nut (fig. a, page 7).
➤ Slide the cover over the monitor bracket on the monitor.
6.3

Connecting the monitor electrically

The circuit diagram for the LCD monitor can be found in fig. b, page 7:
No.
1
2
3
4
5
A
NOTICE!
Cables and connections that are not properly installed will cause malfunctions or dam-
age to components.
Correct installation of cables and connections ensures lasting and trouble-free opera-
tion of the retrofitted components.
EN
Description
6-pin socket 1 = red on ignition; 3 = black on ground; 2 = white, left turn
signal; 4 = green, right turn signal; 5 = not used; 6 = green reverse gear
Buzzer supply
8-pin supply line from the camera
20-pin plug
Monitor
Installing the LCD monitor
15