Maintenance Schedule; Muffler; To Do A General Inspection; To Clean The Product Externally - Husqvarna LC 151 Manual De Usuario

Maintenance schedule

CAUTION: Make sure that the air filter is up
and not against the ground when you tilt the
product. Risk of engine damage.
Maintenance
Do a general inspection
Examine the oil level
Replace the oil (the first time after 5 h of use, then after each 50 h of
1
use)
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the engine brake handle *
Examine the muffler *
Examine the spark plug. Clean or replace the spark plug if it is nec-
essary
Examine the air filter
2
Clean the air filter
Replace the air filter
Examine the fuel system
Clean the cooling fins on the cylinder
Examine and adjust the clutch wire

To do a general inspection

• Make sure that all nuts and screws on the product
are tightened correctly.

To clean the product externally

• Use a brush to remove leaves, grass and dirt.
• Make sure that the air intake on the top of the engine
is not blocked.
• Do not use a high pressure washer to clean the
product.
• If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
1
If the product is operated with heavy load or in high ambient temperatures, replace the engine oil each 25
hours.
2
Clean more often under dusty conditions or when airborne debris is present. Replace air filter, if it is very dirty.
12
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 8 .
Daily
X
X
X
X
X
X
X
CAUTION: If the product is put with the
air filter down, the engine can become
damaged.
3. Hose down the inner surface of the cutting cover
with water.

To examine the cutting equipment

WARNING: To prevent accidental start
remove the ignition cable from the spark
plug.
WARNING: Use protective gloves when you
do maintenance on the cutting equipment.
The blade is very sharp and cuts can easily
occur.
Monthly Each season
X
X
X
X
X
X
X
X
1566 - 001 - 16.09.2020