Bulb replacing
1. Switch off the refrigerator and pull out power cord from wall socket. Wait
some minutes till the bulb becomes cold.
2. Remove the lamp shield by removing a screw that fixing the shield.
3. Screw out the old bulb and replace a new bulb (Max. 10W)
4. Reinstall the lamp shield and fix it by the screw previously removed.
How To Defrost
Defrost the fridge when the frost accumulated on the evaporator is about 1/8"
thick.Set the thermostat dial to "OFF" or "0" to defrost. Remove all contents
from the freezer compartment. Leave the freezer door open to allow
accumulated ice/frost to melt. Remove large pieces of ice as need. Do not use
hot water or other electric heating devices to melt the accumulated ice. After
defrosting, remove accumulated ice/water and wipe the freezer compartment
with a soft cloth. Restart the unit per starting instructions.
Never use a knife or other sharp instrument to scrape ice/frost from the
inside of the unit.
HOW TO CLEAN
Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or
solvents on any surface.
Exterior:
Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains
and for periodic waxing, use silicon wax.
Interior: Wash shelves and other removable parts in warm sudsy water, rinse
and dry. Wash interior with baking soda solution (3 tablespoons to I
liter of water) or warm sudsy water, rinse and dry.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return thermostat dial to desired
setting.
HOW TO INSTALL
Install fridge in a convenient location away from extreme heat and cold. Allow
sufficient clearance between the fridge and side wall so the door will open
without obstruction. Fridge is not designed for
recessed installation.
Select a space with strong level floor.
Allow 5 inches of space between the fridge's side and
the wall.
The appliance must be correctly connected to the
power supply.
18