Preparation For Use; Level Adjustment; Installation Of The Equipment; Prepare Power Source - Tanita BWB-800MA Manual De Instrucciones

2.Preparation for Use

a

Level Adjustment

Level Gauge
*Adjust the height by rotating the adjustable feet.
a

Installation of the Equipment

8
For accurate measurement, place the unit on as flat a surface
as possible and adjust the level with the adjustable feet so the
bubble in the level gauge is in the center of the frame.
Caution
Place the equipment on a level surface. If the equipment is not
stable, for example because not all the feet are on a level
surface, there is a risk that it will topple over and it will be
impossible to obtain an accurate measurement.
The Display Box can be placed on the table or hung
on the wall.
<When hanging on the wall>
Attach the Bracket for Wall Installation onto the wall using
the screws through the two holes in the Bracket. Ensure
that the protruding edges of the Bracket are uppermost.
Mount the Display Box onto the Bracket, inserting the
hooks of the Display Box into the protruding edges of the
Bracket.
Ensure that the Display Box is firmly fixed to the Bracket by
gently pulling down on the Display Box.
•If the Display Box is not fixed sufficiently, there is a
danger that it may fall down.
•Avoid installing the Display Box in a place where
users may step on or get caught by the cable.
•Do not swing the Display Box by the cable.
a

Prepare Power Source

When using the AC Adapter
plug
socket
Pilot Lamp
When using dry cell batteries
Fixing Screws for the
Battery Compartment
Dry Cell
Batteries
Battery Compartment
Insert the cable plug for the AC Adapter into the socket on the
side of the Display Box, and insert the AC Adapter plug into a
230V AC mains socket.
Then confirm the Pilot Lamp on the AC Adapter lights up.
Warning
•To avoid electric shocks, do not insert and remove the plug
with wet hands.
Caution
•Use only the AC adapter (MODEL: A30930G) specified. Using
an AC Adapter other than that specified may cause
malfunctions.
Unscrew the Fixing Screws for the Battery Compartment on
the right side of the Display Box and pull out the Battery
Compartment. Place dry cell batteries in the correct positions
as instructed inside the Battery Compartment and fix the
Battery Compartment with the Fixing Screws.
If is displayed on the Display and s appears next to
the symbol, please replace all the six batteries with new
ones.
•Please change the batteries carefully to avoid
dropping them on your feet.
•Ensure that the batteries are inserted with the
correct polarity / . If the polarity is incorrect,
then the batteries may leak and damage the
equipment.
•When not in use for a long time, remove the
batteries before storing the equipment.
•When the equipment has been transferred to another
location with a temperature difference of more than
20˚C, leave at least two hours before using.
9