Beurer BC 57 Instrucciones De Uso página 28

feet flat on the ground. Make sure to rest your arm and
move it. Always make sure that the cuff is at heart level.
Otherwise significant deviations can occur. Relax your
arm and the palm of your hand.
• To avoid falsifying the measurement, it is important to
remain still during the measurement and not to speak.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the pos-
ture in which you want to perform the measurement.
• Press the START/STOP button
start the blood pressure monitor. All
displays will illuminate briefly.
The blood pressure monitor will begin
the measurement automatically after 5
seconds.
The measurement is taken during the
inflation phase.
You can cancel the measurement at any time by
pressing the START/STOP button
As soon as a pulse is found, the pulse symbol
played.
• The systolic pressure, diastolic pres-
• EE_ appears if the measurement could not be per-
to
• Now select the desired user memory by
• Press the START/STOP button
.
If Bluetooth
ferred after pressing the START/STOP button
• The Bluetooth
28
sure and pulse rate measurements
are displayed.
formed properly. Observe the chapter on error messag-
es/troubleshooting in these instructions
for use and repeat the measurement.
pressing the memory button M. If you do
not select a user memory, the measure-
ment is stored in the most recently used user memory.
The relevant symbol M1 or M2 appears in the display.
blood pressure monitor. The measurement is then
stored in the selected user memory.
® data transfer is activated, data is trans-
® symbol flashes on the display. The
blood pressure monitor now attempts to connect to the
app for approx. 30 seconds.
is dis-
to switch off the
.