IKA RV 10 control Instrucciones De Manejo página 21

Calculator
It helps you to calculate the boiling point (vapor temperature) of
solvent, heating bath temperature and pressure. If one of the 3
values has been defined, the other 2 values will be given.
Actions after distillation
It is possible to define actions when the measurement is stopped
(manually or automatically).
2. Rotation
3. Timer
Timer function
Time: This setting allows the user to specify the actual time for
the measurement procedure in the manual mode. A default time
can also be set for the timer, which allows the user to start the
measurement task for a standard time. The device stops automa-
tically after expiry of the set time, and the set time used for the
measurement procedure appears on the display.
4. Display
Advanced
Flow control: This setting can be deactivated in the manual mode
if dry ice is used instead of a cooler.
Bath medium: Select either water or oil as the medium for the
heating bath. If water is the medium, please select water, the tem-
perature will be from 20 °C to 90 °C. If oil is the medium, please
select oil, the temperature range will be from 20 °C to 180 °C.
Cooler power limit: This setting is used to limit the cooler power.
If the actual cooler power is higher than the cooler power limit a
warning appears and the measurement is stopped.
Max power of cooler: This value shows the maximum cooler
power value of a measurement. This value serves as information
and cannot be changed.
Interval mode
The rotation can be run in an interval mode of alternating the
rotation direction.
Interval: The interval sets the time how long the rotation takes
place in one direction.
Activate: This entry activates the interval mode for the rotation.
Speed limit
The "Speed limit" menu allows the user to set the desired maxi-
mum and minimum speed limit for the rotation.
Note: The user can stop the measurement procedure before ex-
piry of the set time. In this case the countdown of the timer is
interrupted.
Beep after timeout: This menu item allows the user to turn on/
off the sound that occurs when the timer reaches 00:00:00. A tick
shows that the option is activated.
Activate: In this menu the user can activate or deactivate the
timer function. A tick shows that the option is activated.
Display
In the "Timer" menu the user can specify that the timer is dis-
played on the display/working screen. A tick shows that the opti-
on is activated.
In this menu the user can set which values (Timer, Flow rate, ΔT
and/or Cooler power) should be shown on the main screen. A tick
shows that the option is activated.
21