Frigidaire FGEH3047VFA Instrucciones De Uso página 7

30" ELECTRIC FRONT CONTROL FREESTANDING INSTALLATION INSTRUCTIONS
7. Install filler trim kit
Note: Installation of the filler trim kit is not required.
Disconnect electrical power to range before
beginning installation. Before servicing any part of the
appliance, make sure the appliance is off and the surfaces
are cool. Attempting to service the appliance while hot may
cause burns or other injury.
Filler Trim Attachment Instructions:
1. Remove the 7 screws on the vent trim on the back.
2. Place the filler trim over the back by lining up the 7
screw holes of the filler trim with the vent trim and
tighten screws.
3. When filler trim is secured it will be flush with the top of
the range.
Fig. 19 - Range with filler trim installed.
Fig. 16
Fig. 17
Fig. 18
8. Door Handle Mounting In-
structions (some models)
1. Remove handles from carton and any other protective
packaging.
2. Position handle end caps over left and right pre-
installed shoulder bolts (A) that are fastened to the
door, ensuring the holes for the set screws are facing
down.
3. While holding handle firmly against door, loosely tighten
right Allen set screw (B) with supplied Allen wrench until
there is no gap between handle and door.
4. Still holding the handle firmly to the door, firmly tighten left
Allen set screw (B) with supplied Allen wrench.
5. Return to the right Allen set screw (B) and firmly tighten with
supplied Allen wrench.
NOTE
All set screws should be tightened so the screw is
below the surface of the handle. The handle should be
drawn tight to the door with no gaps.
The door handle may loosen over time or if it was
installed improperly. If this happens, tighten the set
screws on the handles.
7