Sears Kenmore 11091942710 Instrucciones De Instalación página 28

ELECTRONIC CONTROL SET-UP INSTRUCTIONS
Start Operating Set-Up
Insert service access door key, turn, and lift to remove service
access door.
Dryers with Card Reader Installed:
Once the debit card reader is installed (according to the reader
manufacturer's instructions), the set-up mode can be entered
by inserting a manual set-up card (supplied by the reader
manufacturer) into the card slot. If manual set-up card is not
available, only the diagnostic mode can be entered by removing
the service access door.
IMPORTANT: To access set-up mode or diagnostic mode,
use a service key to open the service access door. If a card
reader is installed, a service card may also be available
for accessing diagnostics.
The dryer is now in the set-up mode.
NOTE: It is not necessary to set up the dryer with the following
codes; the dryer is pre-set at the factory. These codes can be
used to change settings, if desired.
Set-Up Codes
The PERM PRESS button will advance from code to code.
■
The COTTON/WHITES button will change the code value.
■
The COLORS/DELICATES button will select or deselect options.
■
The set-up code is indicated by the one or two left-hand
characters. The set-up code value is indicated by the two
or three right-hand characters.
NOTE:Thefirstlineofeachcodeindicatesthefactorydefault.
Code Explanation
6 06 REGULAR CYCLE PRICE
6 06 When the d.xx is set to d.00, this 6 xx value represents
the number of quarters (coin 1) needed to start the dryer;
may adjust from 0–39. Change this value by pressing
the COTTON/WHITES button. 6 06 = 6 quarters = $1.50.
6 01 When the d.xx is set to d.CS, this 6 xx value represents
the number of push-in actuations of the coin slide to start
the dryer. 6 01 would equal one coin slide activation.
g
Press the PERM PRESS button once to advance to next code.
7 05 REGULAR DRY TIME
7 05 When set to Coin Drop or Card Reader operation, the dry
time equals the Regular Dry Time value multiplied by the
Regular Cycle Price value. Example: 6 06 and 7 05 =
(06 x 05 = 30 minutes).
7 30 For coin slide or OPL operation, the value is the amount
of minutes of dry time. Pressing COTTON/WHITES adjusts
the value from 1–99 minutes.
g
Press the PERM PRESS button once to advance to next code.
8 00 TYPE OF DRYER PRICING
8 00  F ixedCyclewithTopOff.Onlyavailableforusewith
coin drops or card readers. For detailed description,
see General User Information.
8 FC
Fixed Cycle. For detailed description, see General User
Information. Use COLORS/DELICATES button to make
this selection.
g
Press the PERM PRESS button once to advance to next code.
9 00 CYCLE COUNTER OPTION
This option is either SELECTED "ON"
or NOT SELECTED "OFF."
9 00 Not Selected "OFF."
9 0C Selected "ON" and not able to be deselected. Press the
COLORS/DELICATES button three consecutive times to
select "ON." Once selected "ON" it cannot be deselected.
g
Press the PERM PRESS button once to advance to next code.
28
Code Explanation
1. 00 MONEY COUNTER OPTION
This option is either SELECTED "ON"
or NOT SELECTED "OFF."
1. 00 Not Selected "OFF."
1. 0C Selected "ON."
Press the COLORS/DELICATES button three consecutive
times to select "ON" and three consecutive times to
deselect (Not Selected "OFF"). Counter resets by going
from "OFF" to "ON."
1. C0 Selected "ON" and not able to be deselected.
  Toselect"ON"andnotabletobedeselected,first
select "ON," then within 2 seconds, press COLORS/
DELICATES twice, COTTON/WHITES once, and exit
the set-up mode.
g
Press the PERM PRESS button once to advance to next code.
2. 00 SPECIAL PRICING OPTION
This option is either SELECTED "ON"
or NOT SELECTED "OFF."
2. 00 Not Selected "OFF," and next available code will be A.00.
2. SP Selected "ON." Press the COLORS/DELICATES button
once for this selection.
If SPECIAL PRICING OPTION is selected, you have
access to codes "3.XX" through "9.XX."
g
Press the PERM PRESS button once to advance to next code.
OPTIONS TO USE IF SPECIAL PRICING IS SELECTED:
3. 06 SPECIAL CYCLE PRICE
3. 06 Represents the number of quarters (coin 1) needed to start
the dryer; may adjust from 0–39. (See b.xx set-up for
VALUE OF COIN 1.) Advance from 0–39 by pressing
COTTON/WHITES. Factory default of 6 quarters = $1.50.
g
Press the PERM PRESS button once to advance to next code.
4. 05 SPECIAL DRY TIME
4. 05 Represents the number of minutes per quarter (coin 1).
Factory default of 5 minutes per coin. Example: 6 quarters
x 5 minutes = 30 minutes. By pressing the COTTON/
WHITES button, the value can be adjusted from
1–99 minutes.
4. 30 For coin slide or OPL operation, the value is the amount
of minutes of dry time.
g
Press the PERM PRESS button once to advance to next code.
5. 00 TIME-OF-DAY CLOCK, MINUTES
5. 00 This is the TIME-OF-DAY CLOCK, minute setting; select
0–59 minutes by pressing the COTTON/WHITES button.
g
Press the PERM PRESS button once to advance to next code.
6. 00 TIME-OF-DAY CLOCK, HOURS
NOTE: Uses military time or 24 hr. clock.
6. 00 This is the TIME-OF-DAY CLOCK, hour setting; select
0–23 hours by pressing the COTTON/WHITES button.
g
Press the PERM PRESS button once to advance to next code.
7. 00 SPECIAL PRICE START HOUR
NOTE: Uses military time or 24 hr. clock.
7. 00 This is the start hour; 0–23 hours. Select START HOUR
by pressing the COTTON/WHITES button.
g
Press the PERM PRESS button once to advance to next code.
8. 00 SPECIAL PRICE STOP HOUR
NOTE: Uses military time or 24 hr. clock.
8. 00 This is the stop hour; 0–23 hours. Select STOP HOUR
by pressing the COTTON/WHITES button.
g
Press the PERM PRESS button once to advance to next code.