Makita BUH550 Manual De Instrucciones página 7

When the remaining battery capacity becomes low:
•
Recharge the battery cartridge.
Battery remaining capacity indicator
(only for models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light for
approx. three seconds.
Indicator lamps
Lighted Off Blinking
E
011713
When only the lowermost indicator lamp (next to
•
the "E") blinks, or when none of the indicator lamps
light, the battery capacity has run out, so the tool
does not operate. In these cases, charge the
battery or replace the empty battery with a fully
charged one.
When two or more indicator lamps do not light even
•
after charging is complete, the battery has reached
the end of its service life.
When the upper two and lower two indicator lamps
•
light alternately, the battery may have malfunctioned.
Contact your local Makita authorized service center.
NOTE:
The indicated capacity may be lower than the actual
•
level during use or immediately after using the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
1. Indicator lamps
2. CHECK button
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Battery adapter (Accessory)
3
1. Battery cartridge
2. Button
3. Adapter
4. Hook
5. Tool
011149
1
011229
CAUTION:
Before using battery adapter, read all instructions
•
on tools using battery.
When charging a battery cartridge, first remove it
•
from the battery adapter and then charge it. It is not
allowed to charge the battery cartridge while using
battery adapter.
Installing or removing battery adapter
Always switch off the tool before insertion or
•
removal of the battery adapter.
To remove the battery adapter, withdraw it from the
•
tool while sliding the button on the adapter.
7
1
5
2
3
1. Hook
2. Belt
2
2
4