Cleaning And Maintenance - Domo DO1001SV Manual De Instrucciones

WALL FIXING
· Hold the wall fixing in a vertical position against the wall.
· Mark the holes with a pencil.
· Drill the holes in the wall and insert the plugs supplied.
· Use the screws to secure the wall fixing.
· Place the motor unit on the fixing to store it.

CLEANING AND MAINTENANCE

THE DUST CONTAINER
Never exceed the maximum indicator on the dust container.
Empty the dust container by pressing the release button on the bottom. The dust container
falls open and you can then remove the coarse dirt.
THE FILTERS IN THE DUST CONTAINER
There are two filters in the dust container: the plastic coarse dirt filter (A) and the HEPA filter
(B).
1. Remove the dust container from the motor compartment of the chopper by rotating it
clockwise. Make sure that the mark on the motor unit is aligned with the release lock
symbol.
2. Pull the filters out of the dust reservoir. Remove the HEPA filter from the coarse dirt by
pulling it upwards. Blow compressed air through the filters to clean them. You can also
wash the filters under running water. Take care to dry them completely before using
them again in the appliance.
www.domo-elektro.be
A B
41
DO1001SV