Problem And Solution - Domo DO1001SV Manual De Instrucciones

3. Remove the rotating floor brush from the floor nozzle.
4. Remove hairs and other dirt that have wrapped around the floor brush. If you do not
clean the floor brush regularly, it will become damaged and your machine will become
unusable.
5. Then place the rotating brush back in the floor brush. Make sure that the triangle on the
rotating brush is aligned with the triangle in the floor brush. On the other side, the round
end of the rotating brush needs to be tilted downwards.
6. Use a screwdriver to put the lock back in place.
CLEANING THE MACHINE
Clean the machine with a slightly moist soft cloth. Dry the machine off well. Never submerge
the machine in water!

PROBLEM AND SOLUTION

Problem
The machine does not start up.
The machine does not vacuum.
The running time of the machine
is shorter and shorter.
The indicator light does not burn
while charging.
www.domo-elektro.be
· The battery is empty. Charge the machine.
· The battery is not inserted properly. Insert the
battery until it clicks into place.
· The filters are dirty/the dust reservoir is full.
· The floor nozzle is clogged/the floor brush is blocked.
· The nozzle opening is clogged.
· Clean the machine as described in this manual.
· The machine is not sufficiently charged. Charge the
machine fully and try again.
· The battery is broken or old. Replace the battery.
· Stuck hairs.Remove the hairs stuck on the brushes.
· There is poor contact.
· Check that the adapter is connected properly.
· Remove the dust on the connector of the upright
vacuum cleaner
Solution
43
DO1001SV