Important Recommendations; Equipment Safety; Working Area - TRAPP ES-450 Manual De Instrucciones

www.trapp.com.br
Congratulations!
You have just acquired a quality product with the highest technology developed by
TRAPP. This product was designed to work quickly and efficiently, providing total
safety at low cost. Safety measures should be followed to operate this equipment.
The safety measures stated in this operating instructions do not cover all possible
situations that may occur during usage. The operator must be aware that common
sense, attention, and precautions cannot be incorporated into the product, therefore
caution should be taken when operating and servicing TRAPP shredders.
Attention!
Read all the instructions in this manual
before operating the equipment. Always
observe and follow the safety indications
to prevent accidents and/or injuries.
Read and keep these instructions

1 - Working area

Do neither use the equipment near explosive

environments nor near flammable liquids, gases
and/or dust under suspension. The equipment
electrical installation produces sparks that may ignite
flammable liquids, gases or dust under suspension.
Never let the ES-450G gasoline-powered engine

operating in closed
environments. The exhaust gas contains carbon
monoxide, an odorless and lethal gas.
Keep children and spectators away. People,

especially children, as well as pets must remain at a
safe distance from the working area, 10 m, when the
equipment is being used. The operator/ user is
responsible for accidents that may occur.
Observe the direction towards which the material

shredded by the silage machine will be launched
through the output spout before turning the
equipment on.

Important Recommendations

or poorly ventilated

2 - Equipment safety

Do not expose the equipment to either rain or

humidity. Install the equipment in a dry place,
protected from weather conditions. Water
inside the equipment can damage the electric
circuit of the motor, besides increasing the risk
of an electric shock.
For your safety, ground the equipment.Failure to

do so may result in an accident, electrical shock
or personal injury, in case of electric motor-
powered machine.
If you need maintenance and spare parts, get in
touch with you local distributor or an authorized
technical assistant:
In case of further difficulties, get in touch with:
METALÚRGICA TRAPP LTDA.
Av. Pref. Waldemar Grubba, 4545 - Cx.P. 106
89256-502 Jaraguá do Sul - SC - Brasil
Phone: +55 47 3371-0088 / +55 47 2107-8800
Fax: +55 47 3371-1997
e-mail: trapp@trapp.com.br
39