Safety Warnings; Product Description - Fracarro SIG7720 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 65
The product must be installed only by qualified persons, according to the local safety standards and regulations.
It is classified as Class II, in accordance with EN 60065 and, for this reason, it shall not be connected to the
protective earth (PE) of the supply mains. The product must be installed in an Headline Sub-rack and it must not
be connected directly with an external power cable.
Installation warnings
The product must not be exposed to dripping or splashing and thus it shall be installed indoors, in a dry
place.
Humidity and condensation could damage the product. In case of condensation, wait until the product is dry
before using it.
Don't install the product above or close to heat sources, in dusty places or where it might come into contact
with corrosive substances.
Leave enough space around the product housing to ensure sufficient ventilation; an excessive temperature
and/or an excessive heating may affect the performance and the life of the product.
To prevent injury, this product must be securely connected to a Sub-rack, in accordance with the mounting
instructions, given in Chapter 3.
In accordance with the European Directive 2004/108/EC (EMC), the product shall be installed using devices,
cables and connectors that allow to comply with this directive requirements for fixed installations.
Fracarro Radioindustrie SpA is not responsible for the possible network diffusion of the television signal de-
coded by SIG7100. The installer and the product user must follow the user conditions provided by the service
provider and those specified in the purchasing agreement of the "smart card".
Therefore, Fracarro Radioindustrie SpA is relieved from any civil or criminal responsibilities due to a breach of
juridical regulations in the matter and arising from any improper use performed by the installer, by the user or by
third parties.
Earthing of the antenna system
The Sub-rack, where the unit will be installed, must be connected, directly or through the rack, to the earth
electrode of the antenna system, in accordance with standard EN 50083-1, section 10. It is recommended to
follow the provisions of EN 50083-1 and not to connect the Sub-rack or the rack to the protective earth (PE) of
the supply mains.
IMPORTANT: Never remove the product cover, parts at hazardous voltage could be accessible when the prod-
uct case is opened. Only instructed and authorized persons can open the product. In case of failure, do not try
to repair the product; otherwise the guarantee will no longer be valid.
The SIG7720 module receives a digital data stream (Transport Stream) coming from digital receiver (i.e.
SIG7100) trough the HeadLine back panel connector; it selects a series of programs within the digital
terrestrial multiplex and sends them to the IP network. The resulting IP stream is sent in multicast mode
to reduce the global IP traffic on the network because it is sent by the Ethernet switches only to the
customers that ask for it.
The signal on the IP is received and displayed by using an IP-Set Top Box or a PC.
Each single SIG7720 module can select and incapsulate over IP the video digital terrestrial uncrypted
programs; each one of them can be assigned to a single multicast IP address.
IMPORTANT: for the correct functioning of the module, the 20Mbit/s maximum
through output for each SIG7720 module should not be exceeded (refer to the
MEASURE -> TOTAL Kbps menù on the TPE or WEB MANAGEMENT -> PROGRAM
LIST ->TOTAL Kbps on the WEB interface menù).

1. SAFETY WARNINGS

2. PRODUCT DESCRIPTION

23

Publicidad

Tabla de contenido
loading

Tabla de contenido