Fracarro SIG7720 Instrucciones De Uso página 35

PRESET --> Available list of pre-settings;
REBOOT --> SIG7720 module restarting (the operation lasts about 15 seconds; during the restart op-
erations, all the LEDs on the front panel are off).
LOGOUT --> Command to exit the WEB Interface management interface.
NOTE – For SIG7720 settings it will be necessary to login once by using Username and Password
by default setting.
5. Enter the NETWORK menu to set/change the IP address, the SUBNET MASK, the WEB SERVER
Port and the DEFAULT GATEWAY previously associated to the streamer (SIG7720). From the mod-
ule, it is possible to enable or disable the DHCP function (automatic assignment of the IP address
from the network). By default, this option is disabled.
WARNING: do not use the HTTP port already occupied by others software process running.
After setting all the parameters, confirm them with the SAVE command. Reset an IP address belonging
to the same sub-network in the network card of the local PC that is used for programming.
NOTE - the SAP Server (Session Announcement Protocol) function, if enabled, allows to send
network information concerned the programs tuned by the module; in this way you will get faster
viewing if you use the VLC software or easier IP- Set top box tuning (if the protocol is supported).
When using SAP function is necessary to associate only one program for each multicast group.
The PCR Restamping function (if enabled) is a technique that allows to reconstruct the temporal
information within the stream where they were distorted (re-synchronization of multicast pack-
ets sent out).
In order to avoid loss of synchronization in streaming video playing, if the function is managed by
PCR restamping IP-Set Top Box or used by the player will be disabled in the module.
Username --> admin
Password --> fracarro
35