Product Installation - Fracarro SIG7720 Instrucciones De Uso

The device is equipped with the following:
• Operation and signal LED (see summarizing table);
• 1 RJ-45 connector (LAN 10/100 Base-T) which allows the setup of the module parameters (i.e. Eth-
ernet parameters, INPUT settings, OUTPUT settings) by an integrated web-browser interface. After
the configuration it's possible to connect the module the LAN network.
ATTENTION: the last pages of these instructions (TECHNICAL SPECIFICATIONS) show the complete
list of characteristics.
The SIG7720 module is installed in the sub-rack of the NewHead Line (SIG7901 or SIG7902) series as
per the following photos. Take the module out of its packaging and install it in the wanted position. The
packing contains the following parts:
• SIG7720 module;
• User's manual;
After the insertion, fix the module
using the screws contained in the
accessory bag. It's a "plug and play"
installation; therefore, the module is
ready to operate.
To remove the module use the handles included in the New Headline sub-rack.. Remove from the back-
panel the screws of the module's to be replaced and insert the extractors into the rectangular slots.
Rotate the extractors 90° to form a handle. Pull the handle with your hand to extract the module. Be
careful because, after a first effort to detach the module from the bottom panel connectors, the module
can be easily removed. While removing the module, be careful not to touch the covers because they
can cause small grazes.

3. PRODUCT INSTALLATION

Fig. 1
24
Insert the module in the card gui-
des and gently push back to lock
them to the back-panel.
Fig. 2