Imperia PastaPresto Manual De Instrucciones página 6

DESCRIPTION OF THE MACHINE
A - Machine body
B - Handle
C - Clamp
D - Cutter roller attachment slot
E - Clamp housing slot
V - Clamp screw
Before each time of use: follow the instructions given in the "Cleaning and maintenance"
paragraph.
1 - Set the pasta machine (A) near the edge of firm surface able to bear its weight, insert
the clamp (C) in the clamp housing slot (E), tighten the clamp screw (V) until the machine is
firmly clamped to the resting surface.
2 - Keeping the lever (L) pressed, turn the adjustment knob (G) to position 6 (max roller
opening), insert the handle (B) in the attachment slot ( F) of the machine, lay part of the pre-
viously prepared dough on the stretching rollers and turn the handle clockwise (making the
stretching rollers turn). This will obtain a first shaping of the sheet. Fold it in two and pass it
through the rollers again to make it homogeneous.
3 - To reduce the thickness, turn the adjustment knob (G) clockwise to reduce the distan-
ce between the stretching rollers (H).
Pass the dough through again repeating the operation until obtaining the required thickness.
4 - To cut the sheet with the cutter rollers (I), after choosing the required cutting size, remo-
ve the handle (B) from the attachment slot (F) and insert it in one of the attachment slots (D).
Rest one end of the sheet on the cutter rollers (I) and turn the handle counter-clockwise.
5 - The dough must be kept at room temperature.
After each time of use: Follow the instructions given in the "Cleaning and maintenance" paragraph.
MANUAL ACCESSORIES OF THE IMPERIA LINE THAT
CAN BE ADAPTED TO PASTA PRESTO
M - IMPERIA RAVIOLI MAKER
N - IMPERIA MILLEGNOCCHI (gnocchi maker)
O - IMPERIA SIMPLEX (single cutter)
P - IMPERIA DUPLEX (double cutter)
Before each time of use: follow the instructions given in the "Warnings" page of the
"Cleaning" paragraph. Set the pasta machine near the edge of firm surface able to bear its
weight, insert the clamp in the clamp housing slot, tighten screw until the machine is firmly
clamped to the resting surface.
2 - Connect the required accessory to the retainer fins provided on the machine.
3 - Insert the handle provided in the slot present on all accessories.
This procedure is the same for all the manual devices shown on this page with the letters
M, N, O, P.
MANUAL USE OF ACCESSORIES
Before each time of use: follow the instructions given in the "Warnings" page of the
"Cleaning" paragraph.
USE OF THE MACHINE
FITTING ACCESSORIES
F - Stretching roller attachment slot
G - Adjustment knob
H - Stretching rollers
I - Cutter rollers
L - Knob lever
(Fig.3)
(Fig.1)
(Fig.2)
(Fig.4)