Publicidad
Idiomas disponibles
Idiomas disponibles
Intended Use
The Dry-Wall Sander ETS 225 is made for professional use. Together with
the appropriate sanding paper or grid, e.g. plasterboard as well as
chipboard joints can be sanded.
Attention!
Safety Instructions
Safe work with this machine is only possible if you read
this operating instruction and follow them strictly.
Additionally, the general safety instructions of the leaflet
supplied with the tool must be observed. Prior to the first
use, the user should absolve a practical training. Save all
warnings and instructions for future reference.
If the connection cable gets damaged or cut during use, do
not touch it, but immediately pull the plug out of the socket,
Never use the tool with a damaged connection cable.
The tool must neither be wet nor used in humid environment.
Do not use the tool near explosive materials.
Do not work with materials containing asbestos.
Modifications of the tool are prohibited.
Always check the tool, cable and plug before use.
Have damages only repaired by specialists. Only insert the plug into
the socket when the tool switch is off.
When the machine runs outside, always use a protection switch (30 mA
max.) against fault current.
Pull the plug out of the socket and make sure is switched off when the
machine is not under supervision, e.g. in case of putting up and
stripping down, in case of voltage drop or when fixing or mounting an
accessory.
Switch the machine off if it stops for whatever reason. This way you
avoid that it starts suddenly and not under supervision.
Only with the original Eibenstock sanding paper
or grid and for this purpose optimised Wet/Dry
Vacuum Cleaner DSS 25 M / DSS 35 M iP an
optimal extraction can be assured. In order to
protect the user and the machine, the use of the
industrial vacuum cleaner is compulsory.
In case of non-observance, you might void your
warranty claim.
13
Publicidad
