Replacing The Lamp; Installation - AEG S73800KMM0 Manual De Instrucciones

12 www.aeg.com
Problem
Upper or lower
square is shown in
the temperature
Display.
dEMo appears on
the Display.
The buzzer sounds.
The Display is red.

6.1 Replacing the lamp

1
6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
Possible cause
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (dEMo).
The door is not closed
correctly.
2
Solution
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not
be possible).
Keep pressed approxi-
mately 10 sec. the OK but-
ton since a long sound of
buzzer is heard and the
Display shut off for a short
while: appliance start works
regularly.
Refer to "Door open
alarm".
1. Switch off the appliance.
2.
Press on the rear hook and at the
same time slide the cover in the di-
rection of the arrow.
3. Replace the lamp with one of the
same power and specifically de-
signed for household appliances.
(the maximum power is shown on
the lamp cover).
4. Slide the lamp cover into its original
position.
5. Switch on the appliance.
6. Open the door. Make sure that the
light comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.