3
Remove the water tank from the
dehumidifier (fig.v).
4
Insert the Philips provided hose into
the drainage hole (fig.{).
5
Push the protective cover of
drainage outlet rightwards to open
it (fig.|).
6
Connect the hose to the drainage
outlet (fig.}).
7
Put the water tank back into the
dehumidifier (fig.y).
Note
•
Put the water tank back in to
the dehumidifier even using
the continuous drainage, or the
dehumidifier can not operate
normally.
•
Make sure the hose fits tightly
so that no water leaks from the
dehumidifier.
When using the continuous
•
drainage, make sure the hose is laid
flat and not knotted.
•
Make sure the hose is not immersed
in water, nor raised higher than the
continuous drainage hole.
Place the outlet of the hose in
•
somewhere it can easily drain.
Check the dehumidifier once a week
•
when draining water continuously
or left unattended for an extended
period of time.
12
EN
6 Cleaning
Note
Always turn the appliance off and
•
unplug the appliance from the
electrical outlet before cleaning.
Never immerse the appliance in
•
water or any other liquid.
•
Never use abrasive or aggressive
cleaning agents such as bleach
or alcohol to clean any part of the
appliance.
Only the pre-filter is washable. The
•
air purification filter is not washable.
•
Do not attempt to clean the filter or
air quality sensor with a vacuum.
Cleaning the body of the
dehumidifier
Regularly clean the inside and outside
of the dehumidifier to prevent dust from
collecting.
1
Use a soft, dry cloth to clean both
the interior and exterior of the
appliance.
2
The air outlet can also be cleaned
with a dry, soft cloth.