SEAL 80Pro Manual De Uso página 29

Pull roller locking knob (8);
Snap-lock (right-hand side, seen from the rear of the machine) to lock the top pull roller
into position.
Pull roller handle (9);
Handle to lever the top pull roller into position.
Main power switch (10);
Rotary switch to switch the mains supply to the machine ON or OFF.
The switch can be locked in the OFF position with a padlock.
Pull roller cover-plate lock (11);
Retaining block and locking screw with knob.
Release the retaining block by unscrewing the knob and turn the retaining block a quarter
to lock or release the cover plate.
Slitters (12) (optional);
Figure 14: Slitter controls
Slitters are used to cut off the edges with an adjustable width from the result when
encapsulating roll to roll.
The slitters (A and B) are sliding along a rail (D) and a tube (F). The position is read on a
ruler (E) on the rear finger protection.
When the knob (G) is pressed, the slitter can slide along the tube which allows us to
change the distance between the two slitters.
The knob (H) unlocks the slitter (A) from the rail (D) and allows us to move both slitters at
the same time and distance. Pressing (H) and (G) on slitter (A) allows to move slitter (A)
without moving slitter (B).
The vertical position of the slitter-knife (up is disengaged, down is engaged) is altered by
pushing down or pulling up the knife holder at (A) and (B).
Operating 27