RIB KS2 Manual Del Usuario página 18

G
B
A -
CONNEXIONS
J1 SEC.TRANSF. Secondary transformer connector
J2 AERIAL Radio antenna
COM Common contact unit
PHOT.1 NC Photocell contact (NC)
LSO Stop opening limit switch M1 (NC)
LSC Stop closing limit switch M1 (NC)
LSO Stop opening limit switch contact M2 (NC)
LSC Stop closing limit switch contact M2 (NC)
STOP Stop button contact (NC)
OPEN Opening button contact (NO)
CLOSE Closing button contact (NO)
K BUTT. Single pulse contact (NO)
A*A Accessory power supply at 24Vac
SIGNAL Gate open light 12Vdc
BUZZER Wiring acoustic warning (12Vdc max 200 mA)
LOCK Electric lock connection (Max 15W 12V)
J3 U - MOTOR 2 MOTOR 2 COMMON CONNECTION UNIT
V-W - MOTOR 2 MOTOR 2 INVERTER AND CAPACITOR
CONNECTION
U - MOTOR 1 MOTOR 1 COMMON CONNECTION UNIT
V-W - MOTOR 1 MOTOR 1 INVERTER AND CAPACITOR
CONNECTION
BLINKER (max 40W )
J4 L1 - N Power supply 230Vac 50/60Hz (on request
120V/60Hz)
J5 PRI.TRANSF. Connector for transformer primary connection
J6 HEATER SUPPLY Connector for heater supply board (Optional -
DO NOT TOUCH THE GUARD! )
J7 ENCODER Terminal board for Encoder M1 and M2
connection
S-M1 Encoder M1 signal
+ M1 Encoder M1 power positive sign
GND Encoder M1 and M2 power negative sign
+ M2 Encoder M2 power positive sign
S-M2 Encoder M2 signal
J8 EXP. Connector for EXPANDER board
J9 RADIO Connector for 24Vac radio receiver
J10 HEATER Connector for heater board control
J11 DO NOT TOUCH THE JUMPER !
IF IT IS REMOVED THE OPERATOR
DOESN'T MOVE !
NOTE: IF THE ELECTRIC LIMIT SWITCHES ARE NOT USED, THERE IS
NO NEED TO BYPASS THEM OUT WITH A JUMPER. THEY CAN
BE BYPASSED IF JUMPER S3 IS OPEN.
18
18