SOLAC ME7710 Instrucciones De Uso página 15

ME7710.book Page 15 Friday, December 28, 2007 9:25 AM

Do not use the appliance for more than 15 minutes. Using the appliance
continuously for more than 15 minutes may cause it to overheat,
reducing the life of the appliance. Let it cool down before you continue
using it.
1 Plug in the appliance.
2 Put the switch (2) in the position (B/massage) or in the position (C/
massage + infrared (IR)) position, according to the treatment required
(fig. 3).
3 Fit the corresponding head (7), (8), (9) or (10) for the treatment desired
on the head adaptor (5) (fig. 2).
4 If you wish, put the head protector cloth over the treatment head (11).
5 Set the intensity of the massage using the control (3) according to the
area you are going to work on and its sensitivity to massage. To do this,
turn the control with your finger towards one side or another according
to the intensity setting desired (fig. 3).
6 When you have finished using the massager, put the switch 82) in the
position (A/off).
7 Unplug the appliance.
To perform a massage with the desired effect in each area and for each
treatment, follow the instructions in fig. 3 with regard to which head to
use, the direction in which to massage and the position of the switch (2)
(B or C/massage or massage + IR).
5 Cleaning and upkeep

Do not use solvents, detergents or abrasive products.
1 Unplug the appliance.
2 Use a dry cloth to clean the outside.
Storage
• When the appliance is not being used, unplug it and store it in a cool, dry
place.
• To prevent the cable from becoming damaged, do not twist it, pull it or
wind it around the appliance. If it is damaged, have it replaced
immediately by qualified personnel.
Cleaning and upkeep
en
15