Using The Harness Buckle; Using The Chest Clip; Using The Lock-Offs; Infant Positioning Pillow - Britax BOULEVARD Guia Del Usuario

BRITAX Child Safety, Inc.
1. Unbuckle the harness
and remove the buckle.
See page 38.
2. Route the belly pad
and buckle through the
desired slot in the cover.
NOTE: Slide the end of
the belly pad over the
comfort foam.
3. Slide the buckle retainer
into the front buckle
slot and slide into the
corresponding buckle
position. Ensure the red
release button faces out.
Replace cover.

Using the Harness Buckle

To Fasten:
1. Insert one tongue at a
time into the buckle.
Proper connection is
confirmed with a click
after inserting each
buckle tongue.
To Release:
1. Press the release button
and pull the tongues from
the buckle.
NOTE: Periodically clean
the buckle to ensure
proper operation. See
page 43.

Using the Chest Clip

1. Open the chest clip.
a. Press tabs.
b. Pull apart.
2. Push together
to fasten.
NOTE: Always
position the
chest clip at
armpit level.
24

Using the Lock-Offs

To Open:
1. Open the locking tab.
2. Open the clamp.
To Close:
1. Close the clamp over the
2. Push down on the locking

Infant Positioning Pillow

The infant positioning pillow
is designed to provide better
harness fit and comfort for
infants using this child seat.
IMPORTANT:
positioning pillow must be
used with infants weighing up
to 22 lbs (10 kg) when using
a child seat in a rear-facing
position. Do not use over 22
lbs (10 kg) or in a forward-
facing position.

Seat Positions

This child seat has 3 positions. To adjust, pull the recline
handle then rotate the child seat shell into the desired
position. Release the recline handle, then verify the child
seat has locked into position.
b
a
90°
NOTE: Set the seat position BEFORE installing.
IMPORTANT: Both parts
of the lock-off must be
opened to secure a vehicle
belt.
vehicle belt.
tab where indicated until
a click is heard.
The infant
0°
90°
Position 1 Position 2
BOULEVARD User Guide
1
Locking
Tab
2
Clamp
Locking
Vehicle
2
Tab
Belt
1
Clamp
0°
0°
90°
Position 3
25