Adjusting Buckle Position; Using The Harness Buckle; Using The Chest Clip; Using The Recline - Britax DUALFIT Guia Del Usuario

BRITAX Child Safety, Inc.

Adjusting Buckle Position

Removing the Buckle
1� Unbuckle the harness by
pressing the release button
and pulling the tongues�
2� Pull the seat cover forward�
3� Unhook the elastic bands
at the back of the seat
cover� Pull the seat cover
forward and over the belly
pad�
4� Turn and pull the buckle
retainer through the slot in
the child seat shell�
Positioning the Buckle
IMPORTANT: Select the slot closest to, but not under the
child�
1� Turn and push the buckle
retainer through the slot in
the child seat shell�
2� Pull the belly pad through
the corresponding slot
in the seat cover� Place
the seat cover back in its
original position and attach
the elastic bands�
24

Using the Harness Buckle

To Fasten: Insert one tongue
at a time into the buckle�
NOTE: Proper connection
is confirmed with an audible
click after inserting each
buckle tongue.
To Release: Press the release
button and pull the tongues
from the buckle�
NOTE: Periodically clean
the buckle to ensure proper
operation. See page 43.

Using the Chest Clip

1� Open the chest clip�
a� Press tabs�
b� Pull apart�
2� Push together to fasten�
NOTE: Always position the
chest clip at armpit level.

Using the Recline

IMPORTANT: This child seat must be used in upright
position in booster mode�
This seat may be used in either the upright or recline
position in harness mode�
1� Pull the recline adjustment
handle and adjust the seat
to the desired position (see
page 8)�
a� Ensure that the seat
is locked into the
desired position before
installing in the vehicle�
b� Ensure the top of
the child seat does not rest against the top of the
vehicle seat back while reclining�
c� Pay attention while adjusting the recline to keep
hands clear of any pinch point�
DUALFIT User Guide
25