ECG MTD 206 VSS Manual De Instrucciones página 71

INSTALLATION
Remove all packaging material and take out all the accessories.
Check that the oven is not in any way damaged (dented or damaged door, etc.). Do not install the oven if it is in any way damaged.
Body of the oven: Remove all protective foil from the surface of the oven.
Do not remove the light brown foil which is screwed into the inside of the oven. This foil protects the oven's magnetron.
Place the oven on an even surface, which guarantees a sufficient amount of free space for the correct function of the ventilation openings.
a) Do not block the ventilation openings. The oven could be damaged.
b) Place the oven as far as possible from a radio or television.
The microwave oven can interfere with the signal of the television or radio signal.
Adjustment bolt A:
Plastic frame cover
Installation of a built in cabinet
The cabinet intended for the installation should not
have a back wall. Minimum installation height is
85 cm.
Under no circumstances should you cover the
ventilation/suction openings.
Bolt B:
1.
600
+8
560
min
340
2.
600
+8
560
min
500
18
18
+3
362
(45)
362 +3
(45)
GB
71