Microwave Oven; Programming Functions - ECG MTD 206 VSS Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 124

MICROWAVE OVEN

Example: If you wish to set the heating of food to 80% microwave power for a period of 20 minutes, the setup is as follows:
Press the Microwave button and "P100" will appear on the display.
1)
2)
Using
set 80% power.
Confirm by pressing the Microwave button and "P 80" will appear on the display.
3)
4)
Turn the
until "20:00" is shown on the display.
5)
By pressing the Quick Start/Start button you will start the cooking process. By pressing the Cancel/Stop button you will cancel the
setting.
Note: When setting the cooking time parameter for cooking food the interval values change from seconds to minutes depending on
the total time, see the following:
Total cooking time
Changes by
for 0–1 min
: 5 seconds
for 1–5 min
: 10 seconds
for 5–10 min
: 30 seconds
for 10–30 min
: 1 minute
for 30–95 min
: 5 minutes
Microwave power output table
Sequence
Display
1
2
3
4
5

3. Programming functions

Set the time according to instructions, see Setting the time.
1)
2)
Set the cooking time, you can select a maximum of 3 preparation stages. If one of the preparation stages is defrosting, you should
set it as the first (see Stage cooking).
3)
Press the Clock/Pre-set button, the hour digits will start to flash.
set the hours in the range 0-23 and confirm by pressing the Clock/Pre-set button, the two minute digits will begin to
4)
Using
flash.
set the minutes in the range 0-59 and confirm by pressing the Quick Start/Start button.
5)
Using
6)
The microwave door must be closed as soon as the time appears on the display, which you just set, the oven will beep twice and
begin to cook.
4. Rapid cooking
By pressing the Quick Start/Start button you will start cooking at 100% for 1 minute. Every time this button is pressed again the cooking
time is increased by another 1 minute. Maximum possible setting is 95 minutes.
5. Defrosting based on weight
Press the Weight Defrost button. (Defrost by weight), the display will show "dEF1".
1)
2)
By turning
set the weight of the food. A "g" will light up on the display.
Start the defrost by pressing the Quick Start/Start button.
3)
6. Defrosting based on time
Press the Time Defrost button and "dEF2" will appear on the display.
1)
2)
By turning
set the length of food defrosting time with a maximum duration of 95 minutes.
Start the defrost by pressing the Quick Start/Start button.
3)
7. Cooking according to stages
For cooking a maximum of 3 stages may be set. If one of the preparation stages is defrosting, you should set it as the first.
Microwave power output
P100
100 %
P 80
80 %
P 50
50 %
P 30
30 %
P 10
10 %
GB
73

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido