Using The Audio/ Video Input Jacks; Connecting A Vcr Or Dvd Player - Sanyo DS35224 Manual Del Propietário

Using the Audio/ Video Input Jacks

CONNECTING A VCR OR DVD PLAYER

QuickTips
Switch off TV and external equipment before connecting cables. (Cables are not supplied.)
Make sure all cable
connectors are fully
seated on jacks.
Always match A/V
cables according to
the colors; red for
right audio, white for
left audio and yellow
for video.
A solid Blue screen
with the word Video1
or Video2, displayed
means that the Video
mode is selected, but
no signal is being
detected at the
Video jacks. Check
connections, turn on
external equipment.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
Remote Control
CABLE
VCR TV
DVD SAT AUX
POWER
RESET
INPUT
Press
INPUT key after
connecting cables to
access the A/V inputs.
There is NO need to tune
to a blank channel.
6
Connect a VCR or DVD Player to AV Input Jacks
Connect VCR, DVD Player, or other equipment's Audio Video Out to the TV Audio Video
Input.
For Mono VCR (Single Audio Jack) connect VCR Audio Out to TV Audio (L) Input.
Optional
Connect DVD Player or other equipment's S-Video Out to the TV S-Video In Jack.
Using the S-Video jack overrides the Video (AV1) jack.
Press POWER to turn on the TV. Turn on external equipment also.
To access Audio/Video inputs, press the INPUT key to select VIDEO1 or VIDEO2.
What you will need for connections:
AV Cable – 1
O
PTIONAL
S-Video Cable – 1
Audio Cable – 1
Back View of VCR
IN
FROM ANT.
IN
VHF/UHF
R-AUDIO-L VIDEO
RF
TO TV
CHANNEL
3 4
OUT
OUT
R-AUDIO-L VIDEO
VIDEO AUDIO INPUT
Rear TV A V Input Jacks
C
ONNECTION
COMPONENT AV2 AV1
S-VIDEO
UHF/VHF/CATV
VIDEO
75Ω
(MONO)
L L
R R
AUDIO
DVD Player
COMPONENT VIDEO OUT
Y P P
B R
VIDEO OUT SELECT
S
OPT.
COPONENT
S-VIDEO OUT
R L
DIGITAL
OUT AUDIO OUT VIDEO OUT