Symbols - Funkwerk elmeg ICT 46 Instrucciones De Servicio

PABX elmeg ICT46...880
Base model
Analog connections
Switchable ISDN connections (internal / external)
Slot for a Smart Media Card
Module slots (4 a/b II, 8 a/b, 4UP0, 8UP0*, S01, S0 2 and S0 4)
Module slots (door intercom device, voice announcement and emergency
supply module)
(elmeg ICT880 only) Connector for the elmeg ICT880xt expansion module

Symbols

Please note: different terminal devices will not necessarily have the same dial tones, ringing signals or procedures for use.
For further information on clock frequency and length, please refer to the assembly instructions.
Symbols used
b
Lift up the handset of your telephone.
g
This symbol indicates the call status. You have lifted the handset of your telephone.
a
Replace the handset of your phone in the carriage, or the telephone is idle.
l
Indicates signaling at a terminal device, for example your phone rings.
t
You can dial the desired number.
1x0
One of these symbols indicates that you should dial the digit shown, or a certain character.
*#
=x)
These symbols indicate a selection of digits or characters from which you can choose the appropriate one.
~
X
This symbol prompts you to select a certain digit or character from a list or table.
R
Prompts you to press the flash key (signal key).
q
Indicates that an acknowledgement signal can be heard in the handset.
d
Indicates a conference call.
ICT 46 ICT 88
6 8
1 4
1 1
2 (*1) 2
1 2
— —
English
ICT 880
8
4
1
2
2
1
5