Oase 6600 Instrucciones De Uso página 5

- English -
Installation (cont.)
Dry installation
1. Remove screen from pump.
2. Mount pump to desired area using the
holes on the bottom of the pump base.
3. Attach both adapters to the pump first using the
gasket then connect tubing to the adapters.
○ If needed, cut the adapter using a hacksaw;
consult packaging for tubing size.
NOTE: Tubing is NOT INCLUDED.
● To prevent air from being taken in, ensure that unit
and supply hose are always below the water level.
Start-up
Attention! The pump must never run dry.
!
Possible consequences: The pump will be destroyed.
Protective measures: Check the water level at regular intervals. Always place the unit below water level.
! Attention! The installed temperature sensor automatically turns the pump off, if it is overloaded. The pump
automatically switches on again once the motor has cooled down. Risk of accident!
Install the unit so that it is not exposed to direct sun radiation (max. 104 ºF - 40 ºC).
Important:
●
The unit switches on automatically when power connection
is established.
1. Switching on: Connect power plug to the socket.
2. Switching off: Disconnect the power plug.
Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
1.
Tubing
Adapter
3.
Adapter
Gasket
Tubing
1.
2.
Gasket
Pump
5