Daten Communication / Bus; Mains Connections; Flashing Codes - PAW Friwa Manual Del Usuario

spannungslos
-
re removing
Friwa
mme benutzen
Collective Terminal Block
3.1.3 Data communication / bus
ors Bus
VBus
Nullleiter-Sammelklemme benutzen!
N
Use Neutral Conductor Collective Block
VBus
terminals
+
R1/R2
3.1.4 Mains supply
R3/R4
RP
floating relay

3.1.5 Flashing codes

28
|
+
OK / Set
floating relay
Schutzleiter-Sammelklemme
benutzen
®
Use PE Collective Block
1 (1) A (220 ... 240) V~
2 (1) A (220 ... 240) V~
4 (1) A (220 ... 240) V~
T4A
L'
electro-
semi-
mech. conductor
R1/R2 1 (1) A (220 ... 240) V~
R3/R4 2 (1) A (220 ... 240) V~
4 (1) A (220 ... 240) V~
RP
T4A
electro-
mech. conductor
The controller is equipped with the VBus
with and power supply to external modules. The connection
is carried out at the two terminals marked „VBus" (either
polarity).
The power supply to the controller must be carried out via
an external power switch (last step!) and the supply voltage
must be 220 ... 240 V~ (50 ... 60 Hz). Flexible cables must
L N
be attached to the housing with the enclosed strain relief
and the corresponding screws or be run into the controller
housing in a cable conduit.
conductor L
neutral conductor N (common terminal block)
protective conductor PE (common terminal block)
green:
red/green flashing:
green flashing:
red flashing:
L' L N
semi-
® for data transfer
normal operation
initialisation (10 sec.)
manual operation
sensor defective