Operation And Use; Filling The Appliance; Starting Ice Cube Production - Silvercrest SEMK 105 A1 Instrucciones De Uso

Operation and use

Filling the appliance

CAUTION! PROPERTY DAMAGE!
Never fill hot water into the water tank
►
be between 8 and 25 °C .
NOTE
Before filling the appliance, make sure that the cap is firmly in the drain
►
opening
will flow straight out again .
Open the lid
♦
Use a container such as a measuring cup to fill the water tank
♦
Never exceed the MAX marking .
Replace the ice basket
♦

Starting ice cube production

WARNING
Always use fresh drinking water to prepare ice cubes . Never reuse the
►
water from thawed ice cubes!
Press the
♦
The control lamp
After around 7 –15 minutes, depending on the water and ambient
♦
temperature, you will hear ice cubes start to fall into the ice basket
To remove ice cubes, open the lid
ice cubes using the ice scoop
If the "Ice full" lamp
♦
production is stopped and the appliance stops cooling . As soon as you
have removed enough ice cubes, the appliance will resume production .
NOTE
Sometimes, the finished ice cubes pile up and obstruct the light sensor . Ice
►
cube production is then stopped, even though the ice basket
full . If this happens, use the ice scoop
the ice basket
production will resume automatically .
If the "Add water" lamp
♦
cube production is interrupted and the appliance stops cooling . If you want
to continue producing ice cubes, fill the water tank
section "Filling the appliance" .
■ 46 │ GB │ MT
on the underside of the appliance . Otherwise, the filled water
and take out the ice basket
in the appliance and close the lid
button to start ice production .
lights up permanently green .
. Then close the lid
lights up red, the ice basket
so that the light sensor is no longer obstructed . Ice cube
lights up red, the water fill level is too low . Ice
! The water temperature should
.
and remove the required amount of
again .
is full . Ice cube
to redistribute the ice cubes in
as described in the
SEMK 105 A1
.
.
.
is not yet