Operation And Use; Filling The Appliance; Starting Ice Cube Production - Silvercrest SEMK 105 A1 Instrucciones De Uso

Operation and use

Filling the appliance

CAUTION! PROPERTY DAMAGE!
Never fill hot water into the water tank
►
be between 8 and 25 °C.
NOTE
Before filling the appliance, make sure that the cap is firmly in the drain
►
opening
will flow straight out again.
Open the lid
♦
Use a container such as a measuring cup to fill the water tank
♦
Never exceed the MAX marking.
Replace the ice basket
♦

Starting ice cube production

WARNING
Always use fresh drinking water to prepare ice cubes. Never reuse the
►
water from thawed ice cubes!
Press the
♦
The control lamp
After around 7 –15 minutes, depending on the water and ambient
♦
temperature, you will hear ice cubes start to fall into the ice basket
To remove ice cubes, open the lid
ice cubes using the ice scoop
If the "Ice full" lamp
♦
production is stopped and the appliance stops cooling. As soon as you
have removed enough ice cubes, the appliance will resume production.
NOTE
Sometimes, the finished ice cubes pile up and obstruct the light sensor. Ice
►
cube production is then stopped, even though the ice basket
full. If this happens, use the ice scoop
the ice basket
production will resume automatically.
If the "Add water" lamp
♦
cube production is interrupted and the appliance stops cooling. If you want
to continue producing ice cubes, fill the water tank
section "Filling the appliance".
│ GB │ IE
■ 10
on the underside of the appliance. Otherwise, the filled water
and take out the ice basket
in the appliance and close the lid
button to start ice production.
lights up permanently green.
. Then close the lid
lights up red, the ice basket
so that the light sensor is no longer obstructed. Ice cube
lights up red, the water fill level is too low. Ice
! The water temperature should
.
and remove the required amount of
again.
is full. Ice cube
to redistribute the ice cubes in
as described in the
SEMK 105 A1
.
.
.
is not yet