socomec COUNTIS E36 Instrucciones De Servicio página 14

14
PRÉSENTATION
INTRODUCTION - DARSTELLUNG - PRESENTAZIONE - PRESENTATIE - PRESENTACIÓN - APRESENTAÇÃO
M-BUS COMMUNICATION
M-BUS MEDIA
EN
In a standard configuration, an M-BUS
connection can be used to link up to 250* products with
a PC or PLC, over a range of 1000 metres**.
* depending on the M-BUS master
** depending on the number of products and the
communication speed
Recommendations
The use of a JYSTY Nx2x0.8 mm (0.5 mm²) unshielded
twisted pair is recommended.
If the range of 1000 m and/or the limit of 250 products
are exceeded, a repeater will need to be connected.
→ if the 250 limit is exceeded: only use the secon-
dary address.
M-BUS protocol
The M-BUS protocol operates using a master/slave
structure.
COUNTIS (slave) units are compatible with both pri-
mary and secondary addressing modes.
M-BUS wiring
Wiring with repeater
COUNTIS E36 - Ref.: 540 684 D
Primary addressing can be configured via the product
interface. Secondary addressing uses a fixed, unique
address shown on the front face of the product (
A
M-BUS COUNTIS units also have the «Wildcard
addressing» function which allows products to be sear-
ched for on the M-BUS network.
Option to broadcast to addresses 254 and 255.
In addition, M-BUS COUNTIS units are OMS-
compatible (Open Metering Systems).
M-BUS table
Download from: www.socomec.fr
N 1
M-BUS
≈ 1000 m or 250 products
Repeater
M-BUS
N 1
N 2
MBUS Address:
AASSxxxx 4DE3 yy 02
N 2
Repeater
N 1
).
A
N n
Repeater