Waeco PerfectView LCD250 Instrucciones De Montaje Y De Uso página 38

_RV-250.book Seite 38 Donnerstag, 14. Dezember 2006 4:54 16
PerfectView LCD250
➤
Ensure that the installation location of the camera is sufficiently firm (e. g. to prevent
the camera from being knocked down by branches that may brush the roof of the
vehicle).
➤
Mount the camera horizontally and in the middle of the rear of the vehicle
(a, page 7).
Lay the camera cable so that you can easily access the plug connection
between the camera and the extension cable should you need to detach the
camera. This considerably eases the detachment work.
The most secure type of attachment is with screws fitted through the construction. There
are several points that must be observed in this regard:
➤
Ensure that there is enough space behind the selected installation position to carry
out the installation.
➤
Remember that suitable measures must be taken to prevent water penetrating
through the holes (e. g. by using screws and sealant and/or spraying the outer
attachment parts with sealant).
➤
Ensure that the location on the construction where you wish to attach the camera is
firm enough to allow the camera to be securely attached.
If you are not sure about the location you have chosen, ask your vehicle manufacturer or
dealer.
➤
Hold the camera on the chosen installation location and mark at least two different
points for drill holes (b, page 7).
Using self-tapping screws:
The holder may only be attached to steel metal with a minimum thickness of
1.5 mm.
Observe the following when making the drill holes into the sheet metal:
– Check beforehand that there is sufficient space on the other side for the drill
head to come out.
– Using a hammer and centre punch, make a small dent to prevent the drill
head from slipping.
– Deburr all drill holes and apply rust-protection.
➤
Drill a hole of Ø 4 mm at the previously marked points.
➤
Screw on the monitor holder using 5 x 20 mm self-tapping screws (c, page 7).
Mounting the camera and monitor
38