Switching On And Off Your Midland Btx1 Pro S; Operative "Mode; Maximum Distance; How To Pair Two Midland Btx1 Pro S Units - Midland BTX1 PRO S Manual De Instrucciones

Switching ON and OFF your Midland BTX1 PRO S

Switching the unit on:
Press and hold "Middle" button for approximately 3 seconds until the BLUE
indicator lights.
Switching the unit off:
Press and hold both "Middle" and "Backward" buttons together for approxi-
mately 3 seconds until the RED indicator flashes 3 times, thus lessening the
chances that you might turn off the unit accidentally (especially whilst wearing
gloves).

Operative "mode"

The BTX1 PRO S can operate in three main "mode": Intercom, Phone and
FM Radio.
The 3 multi function buttons can have different functionality depending on
which mode the unit is at that moment.
› In "Intercom mode" the three buttons let you manage the Intercom com-
munications between driver and passenger or bike to bike.
› In "Phone mode" you can manage your Bluetooth mobile phone to place/
answer a phone call or to listen to the music or GPS App. announcement (in
stereo mode). Please use your phone responsibly and safely.
› In "FM Radio mode" you can listen to your favourite radio station in stereo,
seek for a specific radio station and save it (6 memories are available).
You can switch (toggle) from one mode to the other simply pressing the Mid-
dle button for 3 seconds. A voice announcement will tell in which mode you
are on.
The toggle sequence is the following:
› Intercom mode (if another unit has been paired)
› FM Radio
› Phone mode (if a phone has been paired)
Every time you turn on the unit, the default mode is the last used mode.
The Intercom mode and Phone mode are avalaible only if it was previously
paired to another unit or to a phone.
www.midlandeurope.com
If you need to know in which mode the unit currently is, press briefly the "Vo-
lume + " and "Volume –" buttons together. A voice announcement will tell you
the current mode.

Maximum Distance

You can reach 800m intercom distance if you are in line of sight without ob-
structions and interferences (the riders must be always in sight).

How to pair two Midland BTX1 PRO S units

The two units supplied in the same Midland BTX1 PRO S box, are already pai-
red and ready to use, it means you don't need to perform this procedure. The
units are already paired using the Middle button. If the devices are not part of
the same kit, or the units have been purchased separately, you need to first
pair it in order to use it.
To pair the Midland BTX1 PRO S to another Midland BTX1 PRO S unit
To pair the Midland BTX1 PRO S to another Midland BTX1 PRO S unit, you
must first enter the setup mode:
1. Turn off the unit.
2. Press and hold down the middle button about 7 sec., until the Red light is
on permanently.
3. Now press the Middle button for 3 seconds. The Blue and Red lights will
flash.
4. Do the same procedure on the other unit. When successfully paired, each
unit will have the Blue light on for one second and then go back to the setup
mode (Red light always on).
5. Now the pairing procedure is complete, you just need to exit the setup
mode before you can use the units.
6. Double click on the Middle button, the Red light will turn off and the Blue
light will start flashing.
You can use now your Midland BTX1 PRO S.
Attention: remember to switch off all the other Bluetooth device that are not
part of the pairing procedure, only the two devices involved in the pairing must
be turned on.
21