Switching On And Off Your Midland Btx2 Pro - Midland BTX2 PRO Manual De Instrucciones

Wired microphone
Using the Velcro/adhesive strip, place the microphone inside the helmet in front of
your mouth. This type of microphone is more suited for Full Faced helmets. The mini
connector on the microphone allows you choose the microphone that best suits the
helmet you are using.
Description of the
Slide-in mounting kit
To fix the Midland BTX2 PRO onto the helmet, you have to install the slide-in mounting
kit by using the plate with bi-adhesive strip. This method allows you to safely "fix" the
BTX2 PRO unit onto your helmet and to remove it at any time in order to recharge or
store it.
Plate with bi-adhesive strip
The Bi-adhesive plate is already assembled on the slide-in mounting kit.
4
All manuals and user guides at all-guides.com
Clean the application area on the helmet surface, remove the bi-adhesive film and place
the fixing plate on the left side of the helmet by keeping it contact with the surface for
a few seconds.
Fitting and removing your Midland BTX2 PRO
The BTX2 PRO can be easily fitted onto the helmet by sliding it downwards on the sli-
ding mounting kit. BTX2 PRO is maintained in position thanks to the fixing clip located
on the upper section (A). To detach the BTX2 PRO, simply press the fixing clip and
push the unit upwards.

Switching ON and OFF your Midland BTX2 PRO

Switching the unit on:
Press and hold "Middle" button for approximately 3 seconds until the BLUE indicator
lights.
Bi-adhesive
Lock Unlock
A
www.midlandeurope.com