Battery Installation - cecotec bongo A Serie Manual De Instrucciones

ENGLISH
3_Place both feet on the footrest.
4_Press the throttle push button with your right
hand and rotate the handle towards your body.
5_ Press the throttle push button to speed up.
WARNING: Do not ride too fast.
6_Press the brake to stop or decrease speed.
Press the rear fender with the foot to assist the
braking process.
7_Only get off the scooter when riding at very
low speed or when it is stopped.
48
HOW TO CHARGE THE SCOOTER
1. Open the charge port cover. Make sure it is clean and dry.
2. Connect the charger with the battery and the other end to the power supply. Check the
battery indicator is on.
3. The light indicator will turn on red during charging, and will turn Green when it is fully
charged.
NOTE: Once the light indicator turns green, stop charging it. If the battery is left to overcharge
for a long time the battery service life can be affected.
WARNING: Cover the charge port with the anti-dust tab to avoid dust from entering.
Battery interface
Charge port

BATTERY INSTALLATION

How to remove the battery
1. Pull the lock on the battery case.
2. Push the battery up.
3. Once the battery is held up, pull it out horizontally.
ENGLISH
49
advance connected