Starting The Engine - Shindaiwa T350 Manual De Instrucciones

Ocultar thumbs Ver también para T350:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Starting the Engine

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, "I" for ON or START and "O"
for OFF or STOP.
1. Set the throttle lever to "fast idle" by
performing the following:
a. Depress and hold throttle lockout
lever "A".
b. Squeeze and hold throttle lever "B"
(toward the handgrip).
c. Depress and hold throttle lever lock
button "C".
d. While depressing throttle lever
lock "C", release throttle lock lever
"B" and lockout lever "A".
2. Slide the ignition switch to "I" (ON)
position.
3. Prime the engine by repeatedly de-
pressing the carburetor primer bulb
until fuel can be seen flowing through
the transparent overflow return tube.
IMPORTANT!
The primer system only pushes fuel
through the carburetor. Repeatedly
pressing the primer bulb will not flood
the engine with fuel.
4. (Cold Engine Only) Choke the
engine by moving the choke lever
up towards the spark plug (choke is
closed). See Figure 21.
Cranking the Engine
5. While holding the outer tube firmly
with your left hand, use your right
hand to pull the starter handle slowly
upward until you feel the starter
engage. See Figure 22.
6. Start the trimmer by pulling the
starter handle upward rapidly.
CAUTION!
The recoil starter can be easily dam-
aged by abuse!
 Always engage the starter before
attempting to crank the engine.
 Never pull the starter cord to its
full length.
 Always rewind the starter cord
slowly.
IMPORTANT!
T350 Throttle Assembly
Throttle Lock-
out Lever A
Lock But-
ton C
35020
Throttle Lever B
Figure 20
WARNING!
KEEP WELL CLEAR OF THE CUT-
TING ATTACHMENT! THE CUT-
TING ATTACHMENT MAY ROTATE
WHEN THE ENGINE IS STARTED!
 Place the trimmer on the ground
during all starting operations.
 Make sure you have a secure
footing, and keep a firm grip on
the machine as well.
 Keep all bystanders and pets
well clear of the trimmer during
starting.
Make sure the cutting attachment is
clear of obstructions!
Figure 22
C350 Throttle Assembly
Lock But-
ton C
Ignition
Switch
Throttle
Lever B
C35014
Figure 21
Ignition
Switch
Throttle Lock-
out Lever A
Choke
Closed
37022
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C350

Tabla de contenido