Emergency Off; Power Supply Failure At Last Welding; Technical Specifications; Service And Repair Contact - HURNER HST 300 Manual USB 2.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
value at start, in any other case the upper limit depends
on the load value and is calculated as the current at start
plus 15%.

9.2.7 Emergency Off

The welding process has been interrupted by pressing the
STOP/RESET key.

9.2.8 Power Supply Failure at Last Welding

The last welding is incomplete. The welding unit was dis-
connected from the power supply voltage while it was
in progress. To go on using the unit, this error has to be
acknowledged by pressing the STOP/RESET key (see also
Sect. 9.4).
10 Technical Specifications
Nominal Voltage
Frequency
Power
Ingress Protection
Primary Current
Ambient Temperature
Output Voltage
Max. Output Current
Tolerances:
Temperature
Voltage
Current
Resistance
11

Service and Repair Contact

HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specs of
the product without prior notice.
Info
Version April 2019
230 V
50 Hz / 60 Hz
2800 VA, 80% duty cy.
IP 54
max. 16 A
– 20°C to + 60 °C (– 4°F to + 140°F)
8 V - 48 V
110 A
± 5 %
± 2 %
± 2 %
± 5 %
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER HST 300 Manual USB 2.0 User's Manual
17
EN