GRE VISIOPOOL Manual De Instrucciones página 8

Installation on the pool-edge
It is preferable to call in a professional to install and maintain the alarm system.
In accordance with specifi cations of standard NF P90-307/A1, your Gre By VISIOPOOL®
device must be fastened in such a way that it cannot be removed by bare hands
alone.
Your Gre By VISIOPOOL® alarm must be fi rmly fastened to the border of your pool.
The Gre By VISIOPOOL® alarm is equipped with pre-drilled holes and spacers for
fastening it solidly to your pool border (minimum width : 100 mm).
Verify that the support (border, terrace, etc.) is truly stable, since the Gre By
VISIOPOOL® must not vibrate for it to work optimally.
The alarm must be installed switched off , with the cover removed.
Position the alarm in such a way that the plunger tube is at least 5 mm away from the
edge of the border. The Gre By VISIOPOOL® alarm is designed to be fastened to rigid
borders at least 100 mm wide.
• Of the 6 possible fi xation points, you
must use at least 4.
You can choose to use the spacers (Q)
or not in order to obtain the sturdiest
fi xation possible.
The tube of the sensor must be vertical.
• Drill holes and insert pegs (in cement
borders only)
• The foam rubber washers (P) go
directly underneath the housing, or
underneath the spacers if the latter are
used.
• Screw the alarm onto the border using
the 4 screws of the right length.
Page 8
Alarm for swimming pool GRE by VisioPool® - Instruction manual- User Manual
J
Q
P
Q
J
Q
P
Q
P
P
December 2016